1. Purpose

This document provides a description of the QA tests used for validation of STM32MP2 EV1 Kit weekly engineering builds and release builds.

2. Board Preparations

Connect to the board (see https://voxelbotics.atlassian.net/wiki/spaces/DOC/pages/edit-v2/546275360?draftShareId=ce01d92a-ed18-433b-a10f-c3f9f9ac69fb&atl_f=content-tree ):

• Ethernet cable

• WiFi antenna

• USB hub, with USB keyboard and mouse attached, into the USB1 connector.

• HDMI monitor

3. QA Tests

3.1. SD Installation and Booting Test

1. Install release image to SD card, as per https://voxelbotics.atlassian.net/wiki/spaces/DOC/pages/561709076/STM32MP2+EV1+Booting+Linux+from+SD+Card?atl_f=content-tree .

2. Boot to shell prompt using SD card, measure boot time (~25 seconds).

3.2. Empty eMMC Boot Time Test

1. Make sure the system is booted from SD card.

2. Remove partition table from eMMC:
   $ sudo dd if=/dev/zero of=/dev/mmcblk2 bs=8M count=100 conv=fdatasync

3. Reboot and check boot time is about ~25 seconds
   $ sudo reboot

3.3. eMMC Installation and Booting Test

1. Install images to eMMC as per https://voxelbotics.atlassian.net/wiki/spaces/DOC/pages/561709096/STM32MP2+EV1+Booting+Linux+from+eMMC?atl_f=content-tree .

2. Boot to shell prompt using SD card, measure boot time (~25 seconds).

3.4. Ethernet Test

1. Check that internet access is configured automatically.

2. Run ping google.com.