1. Purpose

This document provides a description of the QA tests used for validation of STM32MP2 EV1 Kit weekly engineering builds and release builds.

2. Board Preparations

Connect to the board (see https://voxelbotics.atlassian.net/wiki/spaces/DOC/pages/edit-v2/546275360?draftShareId=ce01d92a-ed18-433b-a10f-c3f9f9ac69fb&atl_f=content-tree ):

• Ethernet cable

• WiFi antenna

• USB hub, with USB keyboard and mouse attached, into the USB1 connector.

• HDMI monitor

3. QA Tests

3.1. SD Installation and Booting Test

1. Install release image to SD card, as per Flashing SD Card with Linux Image from Linux Host .

2. Boot to shell prompt using SD card, measure boot time (~25 seconds).

3.2. Ethernet Test

1. Check that internet access is configured automatically.

2. Run ping google.com.

3.3. HDMI Test

1. Check that login is displayed on HDMI monitor.

2. Login to desktop using USB keyboard and mouse (“user” account).

3. Start Chromium browser (upper left corner->"nine dots"->Chromium browser).

4. Open https://staging.voxelbotics.com page.

3.4. Empty eMMC Boot Time Test

1. Make sure the system is booted from SD card.

2. Remove partition table from eMMC:
   $ sudo dd if=/dev/zero of=/dev/mmcblk2 bs=8M count=100 conv=fdatasync

3. Reboot and check boot time is about ~25 seconds
   $ sudo reboot

3.5. eMMC Installation and Booting Test

1. Install images to eMMC as per Installing Linux to the EMMC Using USB Serial Downloader.

2. Repeat Ethernet, WiFi and HDMI tests while booting from eMMC.