Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 6 Current »

The NAVQ Plus SOM board features an optional Status LED. The color of the LED is green.

Controlling Status LED in Software

The Status LED is turned on by default after the system start up.

To turn the LED off, the following command must be issued in the Linux shell:

sudo sh -c "echo 0 > /sys/class/leds/status/brightness"

The LED is turned on using the following command:

sudo sh -c "echo 1 > /sys/class/leds/status/brightness"

Status LED Kernel Device Tree Configuration

The Status LED is driven by a i.MX8M Plus GPIO pin in the SOM hardware. The GPIO pin is described as follows in arch/arm64/boot/dts/freescale/imx8mp-navq.dts in the Linux kernel source code:

...
        pinctrl_gpio_led: gpioledgrp {
                fsl,pins = <
                        MX8MP_IOMUXC_NAND_READY_B__GPIO3_IO16   0x19
                >;
        };
...

The gpio-leds driver is used to provide software control to the Status LED. The gpio-leds driver's node in arch/arm64/boot/dts/freescale/imx8mp-navq.dts in the Linux kernel source code is as follows:

...
        leds {
                compatible = "gpio-leds";
                pinctrl-names = "default";
                pinctrl-0 = <&pinctrl_gpio_led>;

                status {
                        label = "status";
                        gpios = <&gpio3 16 GPIO_ACTIVE_HIGH>;
                        default-state = "on"; // LED GREEN
                };
        };
...

  • No labels