Page Comparison

...

1. Install release image to SD card, as per Flashing SD Card with Linux Image from Linux Host https://voxelbotics.atlassian.net/wiki/spaces/DOC/pages/561709076/STM32MP2+EV1+Booting+Linux+from+SD+Card?atl_f=content-tree .

2. Boot to shell prompt using SD card, measure boot time (~25 seconds).

3.2. Ethernet Test

1. Check that internet access is configured automatically.

2. Run ping google.com.

3.3. HDMI Test

1. Check that login is displayed on HDMI monitor.

2. Login to desktop using USB keyboard and mouse (“user” account).

3. Start Chromium browser (upper left corner->"nine dots"->Chromium browser).

4. Open https://staging.voxelbotics.com page.

...

1. ~2 min for the first boot)

2. Reboot the board and boot to shell prompt using SD card, measure boot time (~25 seconds for the second time).

3.2. Empty eMMC Boot Time Test

1. Make sure the system is booted from SD card.

2. Remove partition table from eMMC:
   $ sudo dd if=/dev/zero of=/dev/mmcblk2 bs=8M count=100 conv=fdatasync

3. Reboot and check boot time is about ~25 seconds
   $ sudo reboot

3.

...

3. eMMC Installation and Booting Test

1. Install images to eMMC as per Installing Linux to the EMMC Using USB Serial Downloader.Repeat Ethernet, WiFi and HDMI tests while booting from eMMC https://voxelbotics.atlassian.net/wiki/spaces/DOC/pages/561709096/STM32MP2+EV1+Booting+Linux+from+eMMC?atl_f=content-tree .

2. Boot to shell prompt using eMMC, measure boot time (24 seconds for the first boot)

3. Reboot the board and boot to shell prompt using eMMC, measure boot time (~15 seconds for the second time).

3.4. Ethernet Test

1. Check that internet access is configured automatically.

2. Run ping google.com.