...
| Code Block |
|---|
run addip; bootm
## Booting kernel from Legacy Image at 80007fc0 ...
Image Name: Linux-6.1.22
Image Type: ARM Linux Multi-File Image (uncompressed)
Data Size: 8489810 Bytes = 8.1 MiB
Load Address: 80008000
Entry Point: 80008001
Contents:
Image 0: 8480224 Bytes = 8.1 MiB
Image 1: 9574 Bytes = 9.3 KiB
Verifying Checksum ... OK
## Flattened Device Tree from multi component Image at 80007FC0
Booting using the fdt at 0x8081e5ec
Working FDT set to 8081e5ec
Loading Multi-File Image
Loading Device Tree to 2032a000, end 2032f565 ... OK
Working FDT set to 2032a000
Starting kernel ...
Booting Linux on physical CPU 0x0
Linux version 6.1.22 (sasha@workbench.emcraft.com)
(arm-none-eabi-gcc (GNU Arm Embedded Toolchain 10.3-2021.10)
10.3.1 20210824 (release), GNU ld (GNU Arm Embedded Toolchain
10.3-2021.10) 2.36.1.20210621) #2 Fri Sep 1 14:20:49 UTC 2023
CPU: ARMv7-M [411fc272] revision 2 (ARMv7M), cr=00000000
CPU: PIPT / VIPT nonaliasing data cache, PIPT instruction cache
OF: fdt: Machine model: NXP IMXRT1170 EVK board
...
Run /init as init process
[72] Jan 01 00:00:01 Running in background
/ # mmc0: host does not support reading read-only switch, assuming
write-enable
mmc0: new high speed SDHC card at address 59b4
mmcblk0: mmc0:59b4 USD 7.39 GiB
mmcblk0: p1
Micrel KSZ8081 or KSZ8091 40424000.ethernet-1:02: attached PHY driver
(mii_bus:phy_addr=40424000.ethernet-1:02, irq=POLL)
fec 40424000.ethernet eth0: Link is Up - 100Mbps/Full - flow control off
/ # ls
bin hello.ko lib proc sys var
dev httpd linuxrc root tmp
etc init mnt sbin usr
/ # |